There are a number of factors that influence the development of a brazing cycle. These include such things as base metal and braze alloy composition, mass of the assembly and joint design. 

However, each cycle is comprised of a number of common segments. The illustration below shows the typical profile for a vacuum brazing cycle. During the initial pumpdown, water vapour adsorbed by the parts and furnace is driven off. For most brazing applications, a pumpdown before heating to a vacuum level of 8 x 10-4 torr or better is recommended. A vacuum safety interlock should be programmed into the cycle to ensure this level is reached. After pumpdown, the initial heating rate should not exceed 15ºC (30ºF) per minute. Faster rates may cause paste braze alloy to spall off or distortion of the assembly. Heating continues to a stand off temperature at about 25ºC (50ºF) below the solidus temperature of the braze alloy. The load is then soaked at this temperature to ensure temperature uniformity and to allow vacuum levels to recover. A soak time of 30 minutes is usually sufficient, though the incorporation of a second vacuum safety interlock in the braze cycle program may be desirable. READ MORE

This is the last in a series of four articles on Vacuum Brazing Tecniques. (read part 1) / (read part 2) / (read part 3)